Features

° KeySpyers are the smallest keyloggers in the world!

____________________

° Completely undetectable by anti-virus software

° Transparent for computer operation

____________________

° Store up to 8 MILLION characters

° Including special keys (like SHIFT, CTRL, ENTER)

° Data retention without power for over 100 years

____________________

° Independent from operating system in recording mode

° Special software to help retrieve and analyze the data log

° Support for international keyboard layouts

____________________

Compatible with

Requirements

Hardware installation

Installing the KeySpyer is fairly simple — just plug the device in between the keyboard and the PS2 connector.

1. Find the PS2 connector at the computer rear panel.
2. Disconnect the keyboard.
3. Connect the keyboard to the KeySpyer.
4. Connect the KeySpyer to the PS2 port.

On computer power-up the device will self-activate.

For USB models: Follow the same process, except attach to the USB port instead of the PS2 port!

Playback mode (64k - 256k PS2 models)

Once data has been acquired in record mode, you can transmit it to any other computer. Install the KeySpyer Downloader application first (you may obtain it here).

1. Connect the KeySpyer in the same way as in record mode.

2. Run the provided KeySpyer Downloader application. Make sure it is the active application.
3. Type in the password supplied with the device and press Enter. Data download from the KeySpyer will occur automatically. Do not change the active application while transmitting! Transmission can be stopped at any time by pressing a key.
4. Data can now be analyzed and searched.

Memory erasing (64k - 256k PS2 models)

There is no actual need for memory erasing in the KeySpyers, as the memory buffer works in a circular mode. This means, that once memory is full, logging will automatically start over from the first location. However, a special erase option exists, allowing complete hardware 'cleaning' of the internal memory chip.

To initiate memory contents erasing, connect the KeySpyer to the PC (as in standard record mode) and run the KeySpyer Downloader application. Type in the password supplied with the device, followed by Backspace (instead of Enter like in download mode). This will initiate memory cleaning, indicated on the computer by a special dialog. Do not disturb the computer while erasing.

Memory erasing will take typically a few minutes (around 5 minutes for the 64kB version). After the erasing process finishes, the recorder will return to its initial state. Deleted data cannot be retrieved from the KeySpyer!